Start-UP

The device is powered by an Ethernet network cable using the PoE (Power over Ethernet) standard. The Ethernet cable connected to the reference station should be connected to the PoE connector in the power supply or to the appropriate PoE port on the router or network switch. When using the existing network infrastructure, you should remember about the appropriate PoE supply voltage. The cable providing access to the Internet should be connected to the LAN socket on the power supply.

After connecting the device to the power supply, the reference station turns on automatically and the start-up process begins immediately. The device is ready for operation a few minutes after being connected to the power supply. During the start-up process all 3 LED’s are blinking with the same pattern.

The operating status of the device is indicated by the LED diode in the button. The LED colors inform about the operation of the reference station. The colors

Orange color – Sattelite SNR

Solid blue: Excellent signal (5 bars) > 40 dB

4 fast blinks every 5 seconds: good signal ( 4 bars), 25- 40 dB

3 fast blinks every 5 seconds: good signal ( 3 bars), 25 – 40 dB

2 fast blinks every 5 seconds: fair/poor signal ( 2 bars), 15 – 25 dB

1 fast blink every 5 seconds: very low signal (1 bar), 10 – 15 dB

Led is off: no signal, or very poor signal.

Green color – INTERENT

Led is ON – internet connection is OK.

Led is blinking (single blink) – no internet connection from LTE. Selected internet source is LTE.

Led is blinking (double blink) – no internet connection from eth. Selected interent source is eth.

Led is blinking (tripple blink) – no internet connection from WiFi. Selected interent source is WiFi.

Blue color – information about the operating mode of the GNSS module.

LED is ON – corrections are ok and RTCM 1005 message is present

LED is ON for 10 sec. and OFF for 1 sec. – corrections are present but no RTCM 1005 message.

Led is blniking (single blink) – base station is in survey-in or survey-in and fix mode. Corrections are nto sent.

Led is blinking (double blink) – base station is in RTk and FIX mode. Corrections are not sent.

LED is off – no correction messages.